保定巨盛模具制造有限公司

路沿石的安装形式

Installation form of curb stone

路沿石的形式有立式，斜式和平式等。在路沿石上行走，既简单又有效的步行方法来调节身体的五脏六腑平衡，既可增加乐趣，又可防病治病，延年益寿，起到保障行人、车辆交通安全和保证路面沿缘整齐的作用。从路面基层挖槽、安装、路沿石背覆加固介绍了路沿石的施工工艺,并总结了路沿石的质量要求及注意事项,以期保证施工质量,提高道路美观性。

The form of the curb is vertical, oblique and peaceful. Walking along the stones is a simple and effective way to regulate the balance of the body's viscera and viscera. It can not only increase the fun, but also prevent and cure diseases, prolong life, play a role in ensuring the safety of pedestrians, vehicles and ensure the road edge neat. This paper introduces the construction technology of roadside stone from the excavation, installation and backing reinforcement of roadside base, and summarizes the quality requirements and precautions of roadside stone in order to ensure the construction quality and improve the road aesthetics.

材质要求

Material requirements

路沿石石料采用质地均匀的天然麻石机械切削加工而成，石材的强度必须合格，要求其色泽均匀，表面无裂纹，棱角完整，外观一致，无明显斑点、色差，不允许有风化现象，装卸时不准摔、砸、撞、碰，以免造成损伤。

The stone along the road is machined with natural flax stone with uniform texture. The strength of the stone must be qualified. The color and lustre of the stone must be uniform. The surface of the stone must be crack-free. The edges and corners are complete. The appearance of the stone is uniform. There are no obvious spots and color differences. Weathering is not allowed. No falling, smashing, collision or collision is allowed during loading and unloading.

加工要求

Processing requirements

按统一长度进行下料，外露面必须机切抛光，长度允许误差在±20mm范围内，宽度、厚度、高度允许误差在±2mm范围内。

The outcrop must be machined and polished according to the uniform length. The allowable error of the length is within (+) 20mm, and the allowable error of the width, thickness and height is within (+) 2mm.

施工要求

Construction requirements

1.路沿石必须挂通线进行施工,按侧平面顶面示高标线绷紧，按线码砌侧平石，侧平石要安正，切忌前仰后合，侧面顶线顺直圆滑平顺，无高低错牙现象，平面无上下错台、内外错牙现象。

1. The construction along the road must be carried out by hanging through the line, indicating the tension of the high mark line on the top surface of the side plane, laying the side flat stone according to the line code, and keeping the side flat stone in order. Do not lean forward and backward, the side top line is straight and smooth, no high and low misalignment, no upside and downside misalignment, internal and external misalignment.

2.路沿石必须座浆砌筑，座浆必须密实，严禁塞缝砌筑；

The 2. way stone must be built in slurry and the slurry must be dense.

3.路沿石接缝处错位不超过1mm；侧石和平石必须在中间均匀错缝。

The misalignment of the 3. way along the stone joint is not more than 1mm; the side stone and the stone must be evenly sewn in the middle.

4.路沿石侧平石应保证尺寸和光洁度满足设计要求。外观美观，对弯道部分侧石应按设计半径专门加工弯道石，砌筑时保证线形流畅、圆顺、拼缝紧密。弧形侧石必须人工精凿后抛光处理。

4. sides of the side stone should ensure the size and finish to meet the design requirements. Beautiful appearance, the curved part of the side stone should be designed according to the radius of special processing curved stone, masonry to ensure smooth line, smooth, tight joint. The arc side stone must be cleaned after polishing.

5.路沿石后背应还土夯实，夯实宽度不流水槽模具 u型槽模具 电缆槽模具 隔离墩钢模具 护坡砖模具 钢制闸门 螺杆式启闭机 卷扬式启闭机小于50mm，厚度不小于15mm。

The 5. sides along the back of the stone should be compacted with soil. The width of the reinforcement is not less than 50mm, and the thickness is not less than 15mm.

6.路沿石勾缝：勾缝时必须再挂线，把侧石缝内的杂物剔除干净，用水润湿，然后用1：2.5水泥砂浆灌缝填实勾干。

6. Stone joints along the road: when the joints must be hung up again, the debris in the side stone joints removed clean, wet with water, and then 1:2.5 cement mortar filling joints to dry.

7.侧平石勾缝、安砌后适当浇水养护。